-
-
- T-Brick Series 2022
- T-Brick Altay Mirror T-Brick Altay T-Brick Ultra T-Brick Max T-Brick T-Brick Mini
- Dweller Series 2023
- Dweller Max 2.0 Dweller Max Dweller Dweller Ti Dweller Ti - Segmented Chimney Version
Cart
Loadding...
- Contact Us
- Company Info
- NEWS
- About us
- Pomoly Name
- Leave-No-Trace
- Contact Now
- Facebook Group
- YouTube Learning
- Product News
- Contact Us
- Topic Collections
- Policies & Terms
- Payment Policy
- Shipping Policy
- Return & Refund
- Privacy Policy
- Terms of Use
- Tax Policy
- Website Disclaimer
- Safety Disclaimer
- Warranty Policy
- Promotion Policy
- Pre-order Policy
- INTELLECTUAL PROPERTY RIGHTS
- Dealers Agreement And Terms
- User Center
- Forget Password
- My Orders
- Tracking Order
- My Account
- Register
Reviews (6)
Would highly recommend
The wall panel thickness is thicker than any currently on the market so far, and the reinforced supports on the lid and under the belly of the stove are very impressive. The threaded side racks have a brass insert that will fall out over time so I used a pin punch to dimple the leg when it was fully threaded approximately a half centimetre or 1/16 inch from the top on four sides of each tube, this effectively stopped the brass insert from sliding out of the hollow leg just have to be careful not to crush the threaded collar into the inner threads.
On the chimney pipe I used a long smooth pole eight foot or 244 CM in length - one inch or 25.4 CM diameter to gently curve the flexible roll vertically on a very flat rubber sports floor surface of course using the cut resistant gloves and had work gloves on my helper and had the stainless rings laid out every 30 CM or one foot. Be very careful not to wrinkle or crease the pipe before it is formed in to shape and heat treated, if you take your time it will keep its shape unless you excessively fold it. Once heat treated you can roll it Horizontally as it was originally shipped and next time can be vertically rolled much easier as it has a memory to the shape it was heated.
I used a propane Torch to heat treat all surfaces first take off the rubber caps on the rack legs.
You must also be very careful because this can over heat the metal and warp it you must move and keep moving around very quickly paying close attention to the colours - colour range goes from greyish silver to orange to red to purple to blue then to white silver - never heat any part past blue colour or you can risk burning through, if you are not experienced with this I would say stick with using wood to do your first burn. Otherwise I had next to no warping by doing this method but I also have had many years of welding experience, so if you try and fail don't ask for replacement as this is only my tip to you as a fellow consumer.
Good luck and I can't wait to take this hot tent camping.